Read first
Why do I need to check the building before the lease?
The unit is bright, the rent is fair and the landlord has said yes. Three weeks and ₹4 lakh of fit-out later, the electricity board says the connection can only go up to a fraction of what your treadmills and ACs need, and the engineer says the rack zone cannot sit where you planned it. Nothing about a gym is hidden, but all of it is invisible on a first visit.
A gym is heavy, hot, loud and thirsty for power and water. Indian equipment makers and gym-leasing consultants list the same checks: structural load, clear height, sanctioned power, ventilation, drainage, exits and permissions. Do them before the token amount, not after. Your fit-out alone adds 40–80% of the equipment bill to the equipment bill, so a property that needs structural or electrical rework changes your whole budget.
What checks should I make, and what do I do about each?
| Check | What to look for | If it fails |
|---|---|---|
| Floor load | What the slab was designed for. IS 875 Part 2 lists gymnasia at 4.0 kN per sq metre, but that only holds in your building if it was designed for a gym; most rented floors were designed as offices or shops. Ground-floor slabs on soil are the most forgiving. | Ask the landlord for structural drawings. Have a structural engineer approve rack, plate-tree and platform positions, usually near columns and over beams. Move free weights to the ground floor or drop them from the plan. |
| Clear ceiling height | Measured to the lowest beam or duct, not the slab. Design guides put about 3,000 mm (10 ft) as the minimum for a general gym, 3,600 mm (12 ft) or more for functional training with overhead lifts, and more for ropes and rigs. Listing heights are often to the slab. | Measure at the equipment positions. A false ceiling and AC ducts can take 1 to 2 ft off the quoted height. Skip a functional zone if it will not fit. |
| Power | The sanctioned load against what you need, about 10–25 kW for a typical gym floor. The sanction itself takes weeks. A commercial connection, panels and cabling cost about ₹1–3 lakh. | Write into the lease who pays for load enhancement and in what time. Start the application before the fit-out begins. Get an MEP consultant to size it. |
| Fresh air and cooling | A window that opens and space for outdoor AC units. A gym with 40 to 60 people needs far more cooling and air change than a shop of the same size. See ventilation and AC. | Confirm where the outdoor units can sit and that the building allows them. A sealed basement with no fresh-air route is a poor choice. |
| Water and washrooms | At least a working toilet, preferably separate for men and women, a place for showers and a drain. Peak-hour demand is the test, not the average. | Ask whether the landlord allows new plumbing and drains. Check water pressure on an upper floor. |
| Exits, stairs and lifts | Two ways out, clear stairs, a lift that works at 5:30 am, and nothing blocking exits. This feeds your fire and building permissions. | See whether a gym needs a fire NOC and the building's own approval. |
| Column grid and shape | Columns in the middle of a 2,000 sq ft hall cut the lines of sight and the machine rows. A long thin unit wastes floor on a corridor. | Lay out the plan on paper first. See how to lay out the floor. |
| Parking and access | Bays for a peak of two-wheelers, and a safe, lit approach. A gym's crowd arrives in the same hour. | Ask for dedicated bays in writing, or walk away from a gym above a busy street with no parking at all. |
Two further checks sit outside the physical building. Is the building allowed to host a gym under its approved use? Many landlords assume 'commercial' covers it. Check the point in commercial use and zoning. And does the landlord's insurance or society bye-law say anything about gyms? Cover those with landlord permissions.
What changes by type of gym?
- CrossFit boxes and combat gyms are driven by ceiling height and a ground-floor or slab-on-grade spot for drops and rigs. Check box setup and combat gyms before you shortlist.
- Pilates and yoga studios are quiet and light, and can use a first-floor unit with a lower ceiling of about 10 ft. Pool, sauna or steam areas in a premium gym need their own drainage and ventilation; see pool, sauna and steam permissions.
- 24-hour gyms need a safe, separately lockable entrance and an owner who accepts round-the-clock noise.
- Women-only gyms need privacy: solid or frosted glass, a separate changing room and an entrance that is not on a stairwell with other tenants.
What usually goes wrong?
- Trusting the listing's ceiling height and finding 8 ft 6 in under the beams and ducts.
- Leaving the power application until the equipment arrives and having treadmills that cannot run for weeks.
- Putting the racks over a hollow, shaking first-floor slab with a family's flat below, then paying for floor reinforcement or moving everything.
- Assuming the landlord's 'fine' means anything. If it is not written in the lease, it is not agreed.
If a unit passes this list, take it to the lease. If you are unsure about the building, tell us the address type and city and we can help you ask the right questions of the landlord.
Questions people ask
What ceiling height does a gym need?
Guides say about 10 ft clear under the beams for a general gym, and 12 ft or more for functional training, overhead lifts and ropes. Measure to the lowest beam or duct, not the slab.
Can I put free weights on an upper floor?
Sometimes, if a structural engineer approves the positions and the platform build-up, and there are no homes directly below. Many operators keep heavy lifting on the ground floor.
How much electrical load does a gym need?
About 10–25 kW for a typical gym floor, far more for a premium gym with pool and studios. Ask your distribution company what sanction your category needs before you sign.
Who pays for power and plumbing upgrades?
Whoever the lease says. Decide it before signing, along with the rent-free period; see gym lease terms.
This is general information, not legal advice. Have a lawyer read any agreement before you sign it.
Where these numbers come from
- Connected electrical load: 10–25 kW (all India; ask the discom what sanctioned load your category needs before you sign the lease). Reported: Tristar Energy: small neighbourhood gym 10 to 25 kW, boutique studio 8 to 20 kW, premium club 80 to 200 kW. Codingclave suggests a minimum of 5 kW when scouting premises; Fitplex says 15 to 30 kW. The 24-hour range is our judgement, checked 10 November 2026.
- Electrical upgrade and wiring for a gym (commercial connection, load, earthing): ₹1–3 lakh (all India; the sanction itself takes weeks, so start it before fit-out). Reported: CoachFit, ₹1 to 2.5 lakh; Lifefit, ₹1 to 3 lakh, checked 10 November 2026.
Fees, rates and rents change. Check the official source before you pay or sign anything.
Place and setup · Gym or fitness studio
More on place and setup for a gym or fitness studio
31 pages on this. You are on number 19.
- How do I cool and ventilate a gym in an Indian summer, and what does it cost to run?
- How do I renegotiate my gym's rent?
- What should a property have to work as a gym?
- Why do most gyms fail in the first two years, and how do I avoid it?
- Ground floor, first floor or basement: where should a gym be?
- How much power load does a gym need, and what happens in a power cut?
- I am a trainer. Am I ready to open my own gym?
- When should I change my gym's concept: classes, women-only, personal training?
Reading about it is one thing; doing it in your gym or fitness studio is another. If you'd like a hand choosing and setting up the right place, tell us where you are and a person will reply, free.
Get help with this ↓What now?
Where are you?
One tap, and we point you to the right next step.