Buy for the bottleneck, not the brochure. A small wash-fold-iron laundry opens with one or two 10–15 kg commercial washer-extractors, one tumble dryer of matching size, three or four steam pressing tables, a tagging and sorting setup, and a chemical starter set. Dry-cleaning machines, flatwork ironers and boilers can wait until your orders prove you need them.
As a planning estimate, that day-one kit lands around ₹6–12 lakh new, or noticeably less if you buy refurbished and negotiate. Treat every figure here as a ballpark and get written quotes. Water, power and drainage rules vary by city and building, so check them before you pay a machine dealer.
Work out your throughput before you pick a machine
Machine capacity is quoted in kilograms of dry laundry per load, and a load takes roughly 45 to 70 minutes to wash plus 35 to 60 to dry, depending on the programme and the machine. Overbuying is the classic mistake: a 50 kg machine running half-loaded costs nearly as much in water and power as a full one.
| Daily volume (wash only) | Washer-extractor setup | Dryer setup |
|---|---|---|
| 30–60 kg a day | One 15 kg machine, run 3–4 loads | One 15 kg tumble dryer |
| 60–150 kg a day | Two 15 kg machines, or one 25 kg | One 25 kg dryer, or two 15 kg |
| 150–400 kg a day | 25 kg and 50 kg machines, mixed | Dryers sized to about 1.2 times the washing capacity |
| 400 kg and above | Industrial extractors, often with a boiler and ironer | Gas or steam dryers; consider a tunnel finisher for shirts |
Heavy items change the maths. Towels, blankets and hostel bedsheets are dense and wet, so they fill a machine by weight with fewer pieces, while saree and shirt-heavy households fill it by volume. Do a simple count of what your first ten customers will send before you decide.
Must-have on day one
| Item | Estimated cost (₹) | What to look for |
|---|---|---|
| Front-loading washer-extractor, 10–15 kg, commercial | 1.5–3.5 lakh new | Programmable cycles, high spin (extraction) speed, stainless drum, door interlock; avoid domestic washers, which are not built for 8–10 loads a day |
| Tumble dryer, electric or gas, 15–25 kg | 1.5–4 lakh new | Lint filter that opens without tools; temperature control for synthetics; gas versions need a safe LPG or piped gas setup |
| Steam ironing table with vacuum and a small steam generator (per station) | 35,000–90,000 | Heated board, vacuum suction, a boiler or generator that gives dry steam and recovers quickly |
| Steam iron, professional, per presser | 6,000–20,000 | Heavy iron for cottons, lighter one for synthetics |
| Shirt press or collar-and-cuff press | 80,000–2.5 lakh | Only if shirts form a large share of volume; pays back through speed |
| Sorting racks, trolleys, laundry baskets, tag-sorted bins | 30,000–80,000 | Colour-coded bins stop mix-ups between customers' loads |
| Tag gun or barcode labels, marker pens, thermal label printer | 5,000–30,000 | Tagging is your loss-control system; see the tagging section |
| Garment covers, hangers, poly bags and packing tape | 20,000–50,000 as stock | Unit cost of packaging matters at ₹10–20 an order |
| Chemical starter set: detergent, bleach, softener, souring agent, starch, spotting agents | 30,000–80,000 | Buy a dosing pump or fixed-dose sachets so staff are not eyeballing quantities |
| Water softener or filter for the supply line | 30,000–1.2 lakh | Hard water leaves clothes stiff and uses more detergent; test the hardness before you size it |
A single washer, dryer and two pressing stations can run a small household-service business of about 40 to 60 kg a day. Hold back anything that depends on volume you cannot yet show.
Power, water and drainage: the fit-out nobody budgets for
Machines are the visible cost; the building is the hidden one. A 15 kg commercial washer-extractor and electric dryer together can need a three-phase connection or a raised sanctioned load, and the electricity board's charges and wait can be weeks.
- Water: confirm supply per hour, not per day. A busy laundry fills a tank fast. Plan a storage tank of at least a day's use, and an overhead feed for machine inlets.
- Drainage: the outflow is hot, soapy and fibrous. Fit a lint trap or a small settling chamber before the drain, and check with the municipal authority that you may discharge commercial wastewater there.
- Floor: a washer-extractor vibrates hard when spinning. Check the slab, fix anchor bolts or an inertia base, and keep the floor sloped to a drain.
- Ventilation and heat: dryers and steam push out heat and humidity. An exhaust duct for each dryer to the outside, and exhaust fans near the pressing area, change how workers feel by evening.
- Fuel for heat: electric heating is simple but costly per kilo; gas and steam are cheaper to run but need a safe installation, inspection and sometimes registration.
Boilers above a certain size, solvent-based dry cleaning and commercial wastewater discharge can each bring their own registration or consent. We have not verified the thresholds for any particular state. Ask your State Pollution Control Board, the boiler inspectorate and the fire department before you buy, and read the laundry playbook for the licence list. This is general information, not legal advice.
Rent, lease or buy: how to avoid tying up cash
| Option | Good for | Watch out for |
|---|---|---|
| Buy new with a bank or NBFC equipment loan | Owners with a confirmed B2B or society contract | Interest and a fixed EMI before volume arrives; ask whether an Udyam registration helps with loan terms |
| Buy refurbished or second-hand | Washers and dryers where the drum, bearings and electronics can be checked | No warranty and hidden bearing wear; get a running trial, the service history and a technician's inspection |
| Lease or rent machines from a dealer or a pay-per-wash plant | Testing demand in a new area before committing | Terms vary widely; read buy-back and maintenance clauses |
| Outsource to a larger plant first | Dry cleaning, heavy linen, curtains and carpets | You hand over your quality; pick a plant that tags and returns items with your own tags |
Whichever route you take, ask for an annual maintenance contract in writing, with a promised response time. A washer down for four days in the busy season costs more in lost customers than the contract does.
Tagging and tracking kit: the cheapest insurance you will buy
Most claims in a laundry come from lost, swapped or mismatched items, so this category deserves its own budget line even though it costs little.
- Pickup bags with a numbered tag per customer, so a customer's whole load stays together from van to machine.
- Garment tags: a numbered paper or fabric tag stapled or pinned to each piece, or heat-resistant barcode labels. Laundry marking ink on the care label works for hostels and repeat customers.
- Mesh wash bags for delicates, innerwear and small items that vanish into the drum.
- A tally sheet or a handheld device where the count at pickup is signed off by the customer and checked again at packing.
- A phone camera, for before photos of anything valuable, stained or already damaged. It costs nothing and settles most disputes.
Move from paper to a barcode label once you handle more than about 100 pieces a day, and see the software page for how the label connects to an order.
Dry cleaning: why most new owners should not buy the machine yet
A dry-cleaning machine uses a solvent, and the choice of solvent changes the building, training and permissions you need. Perchloroethylene (often called perc) machines have drawn health and environmental controls in many countries, and hydrocarbon-solvent machines have their own fire and ventilation requirements. We have not verified the current Indian position for each solvent, so ask the pollution board and fire department.
| Dry-cleaning route | Typical entry cost (₹) | Comment |
|---|---|---|
| Pick up and send to a trusted partner plant | Nil upfront; the plant takes a per-item rate | Keep your own tags; agree turnaround and damage handling in writing |
| Wet-clean specialist for silk and wool using hand wash and controlled drying | Small; skilled labour is the cost | Not every garment suits it; check the label |
| In-house dry-cleaning machine, 8–15 kg | Roughly 10–30 lakh including installation and ducting | Run it only once dry-clean orders keep it busy most days; a trained operator and a spotting table are essential |
A spotting table and spotting agents, used before the garment goes into any machine, matter more to quality than the machine does. Start with these even if the cleaning itself is outsourced.
What not to buy yet
- A flatwork ironer (calender) until hotel or hospital linen contracts are signed; it is built for sheets and tablecloths and idles on household work.
- A large boiler until two or more pressing stations and a shirt press justify it; a small steam generator per station is simpler.
- Delivery vans. Start with two-wheelers or a hired tempo for society runs, and buy a vehicle only when your routes are fixed.
- Branded uniforms, signage and a fancy store counter before your wash quality and turnaround are consistent.
- A tunnel finisher or garment conveyor, which suit a commercial plant, not a neighbourhood unit.
- Accessories and add-ons such as shoe-cleaning kits or carpet machines, until you have regular requests for them.
If you want to see how customers, workers and an operations screen fit together before you spend on software, look at our TidyBee concept build, and read how to hire for a laundry and how to win your first customers.
Paying for it
More on starting a laundry business
- Start hereThe full playbook →Models, licences, startup costs and the steps to your first customer.
- Go deeperWho to hire →Pressers, washers, spotter, riders and a supervisor, with pay ranges and a vetting task.
- Go deeperGetting customers →Hostels, societies and local businesses, launch pricing, WhatsApp bookings and retention.
Questions people ask
Can I use a domestic washing machine for a laundry business?
You can for a few loads a day, but it is a poor choice. Domestic washers are not built for eight to ten loads daily, their bearings and motors wear out quickly, and warranty usually excludes commercial use. A commercial washer-extractor costs more but spins out more water, dries faster and survives. Start with one commercial unit.
Should I buy a washer-extractor new or refurbished?
New gives you a warranty and a service network, which matters when downtime loses customers. Refurbished can save a lot, but check bearings, the drum, door seals and electronics, ask for a running trial and the service history, and have a technician inspect it. Many owners buy new for the main washer and used for backup.
How many machines do I need for 50 kg of laundry a day?
One commercial 15 kg washer-extractor and one matching dryer can handle about 50 kg a day over a long shift, as a rough estimate, but you will have no backup. Many owners add a second washer or a rented spare once volume is steady. Ask a dealer to size against your real mix of towels, sheets and clothes.
Do I need a boiler to start?
Not for a small unit. A compact steam generator at each pressing station is simpler and usually avoids boiler rules that start at larger sizes. Rules differ by state and capacity, so ask the boiler inspectorate before you buy anything that makes steam centrally. A boiler makes sense once you have several stations, a shirt press or an ironer.
What chemicals does a laundry actually use?
A basic set is a detergent, a bleach (chlorine for whites, oxygen-based for colours), a souring or neutralising agent, a fabric softener, starch for formal wear and spotting agents for stains. Use a dosing pump or fixed doses, store each chemical separately and never mix bleaches. Staff need gloves, ventilation and training.
