Finding suppliers · mobile repair shop · 8 min read

Finding spare parts suppliers for a mobile repair shop

Where Indian repair shops buy screens, batteries and parts: wholesale hubs, part grades, how to test a supplier, dead-on-arrival tracking and credit terms.

Planning this? Ask an expert, free ↓
Homecraft on-demand home repairs and maintenance
Runs on HomeCraft · Home services

Part of the playbook: How to start a mobile repair shop in India: costs and licences

Buy parts from two or three suppliers in your nearest wholesale electronics market, test their first lots on your bench, and keep a log of every failed part by supplier. A repair shop lives on parts quality, and the cheapest screen is usually the one that comes back within a month. Pick suppliers on consistent quality, honest grade labels and a clear return rule, not on the lowest rate.

This page covers the grades you will be offered, where parts come from in India, how to run a supplier trial, how to spot bad lots, and the credit and tax points that decide your margin. Rupee figures are estimates; part prices change with each model and each season.

Know the grades before you negotiate

Suppliers rarely agree on names, and a grade called A+ at one counter is a B at another. Ask for a sample of each grade, hold it up next to a known original and note the differences.

Grade names vary by supplier. Check the actual part rather than the label, and confirm any warranty in writing.
Part and gradeWhat it isTypical failure modes to check
Display: original or pulled-originalGenuine panel, often taken from a donor phone or a factory surplus; priced highestBurn-in, dead pixel lines, a refurbished frame with a weak connector; check it on a tester before accepting
Display: OEM or service-pack styleA made-to-spec panel without the brand's own markings; the middle priceLower peak brightness and colour shift; check touch at the edges and under a charger
Display: hard OLED or incellRigid or lower-grade panels used as cheaper alternatives for OLED modelsHigher power use, colour tint and a poorer fingerprint reader; give a shorter warranty
Battery: original with the brand's chipA genuine cell or a cell from a service packCounterfeit packs relabelled as originals; test capacity and check cycle counts where the phone reports them
Battery: compatible, BIS-markedA third-party pack from a maker that carries the mandatory markCapacity below the label, swelling in months; pay for batteries with the licence number on the pack
Charging dock flex, speaker, mic, camera, vibratorSmall modules sold per modelDifferent flex revision for the same model, and cameras that autofocus slowly or hunt
Back glass and framesCosmetic panelsColour mismatch; adhesive that does not hold; check against the phone's own colour name
ICs and componentsCharging, power-management and audio chips, sold per piece or in lotsSalvaged chips sold as new, mislabelled variants; buy from a seller you can return to

Whichever grade you buy, tell the customer which one you are fitting and give the warranty that goes with it. It protects you when a cheaper part fails, and it lets customers pay for the grade they want.

Where parts come from in India

Most parts reach independent shops from large wholesale clusters, which in turn get stock from importers and from refurbishers who pull and re-grade parts.

Hubs are named as widely known electronics markets; individual shops within them vary in reliability, so test before you trust.
SourceWhat you getWhat to know
Wholesale market hubs: Nehru Place and Gaffar Market (Karol Bagh) in Delhi, Lamington Road in Mumbai, SP Road in Bengaluru, Ritchie Street in Chennai, Jagdish Market in Hyderabad, Chandni Chowk in KolkataA broad range, rates that change daily and a chance to compare grades side by sideGo with a technician the first few times, and ask for a GST bill. Markets have both dependable counters and ones that sell mislabelled grades
Distributors with a city warehouseFixed price lists, an account, delivery within a day and a return policyUsually a better first choice outside the metros; ask for a credit limit and a returns clause in writing
Refurbishers and screen labsGlass-replaced and re-laminated displays, tested and gradedA good way to buy cheaper screens, but check the failure rate and the warranty they will stand behind
B2B marketplaces such as IndiaMARTImporters and traders across cities, useful for tools and hard-to-get partsAsk for samples first, check the GST number on the portal, and call a customer reference
Brand service centres and authorised parts channelsGenuine parts at official prices, with limited access for independent shopsAvailability for independent shops differs by brand; I have not verified current programmes
Donor phonesBoards, cameras, frames and displays from beyond-repair devicesA cheap source for scarce parts on older models, but only with a record of where the phone came from

If you are in a smaller town, the practical route is usually a distributor who travels from the nearest hub twice a week, plus a weekly trip yourself or by your runner. That makes your lead time two to four days for rare parts, so keep stock of what moves.

Run a supplier trial before you commit

Spend the first month testing suppliers on small orders. Treat each lot as an experiment with a record.

  1. Order a small first lot, say five displays and five batteries for popular models, from two suppliers at the same time.
  2. Test on arrival. Use a display tester or a donor phone: touch, colour, brightness, ghost touch and the fingerprint reader. Test batteries for capacity and heat while charging.
  3. Label every part with supplier, date and grade, and keep the supplier's bill in the same box.
  4. Track dead-on-arrival rate (parts that fail the bench test) and comeback rate (parts that fail after fitting within the warranty window) for each supplier.
  5. Review at the end of the month. Keep the supplier whose combined failure is lowest, not the one who looked cheapest.
A shared sheet is enough; fill it once a week.
Supplier scorecard columnWhat to write
Parts boughtCount and grade, by model
Dead on arrivalCount that failed the bench test, and the fault
ComebacksCount that failed in the warranty window, linked to the job card
Return handledDays to replace or credit, and whether the supplier argued
Price versus listRate paid against the market rate on the same day
DeliveryPromised and actual time for urgent orders

A dead-on-arrival rate that you cannot name is a rate you are paying for. Many shops absorb two or three bad parts in ten without noticing, which erases the margin on a screen job.

Spotting bad lots and bad suppliers

  • A price far below the rest for a grade that cost others more is usually a lower grade under a higher label.
  • Sealed packs that look reglued, or labels printed in a different font from earlier lots.
  • No bill, or a bill for a different firm, which means you cannot claim input tax credit and cannot prove where the part came from.
  • Refusal to take back a part that fails the test, or an insistence that the return must be within an hour of purchase.
  • Pressure to buy a large lot of a model that has just been replaced; its parts will fall in price within weeks.
  • Salvaged boards and ICs sold as new, which fail at the first heat cycle.
  • Phones sold as parts donors that carry a lock or a blacklisted IMEI. Do not buy parts or devices that might be stolen; ask for proof of ownership and keep the record.

Buying stolen phones or boards, even unknowingly, can bring police attention and legal trouble. Keep seller ID and a bill for every donor phone, and report anything suspicious. Not legal advice.

Credit, GST and payment terms

Most wholesale counters deal in cash or UPI. A regular account with a distributor can include a credit period, but credit is a cost to the seller that comes back in the price.

Common asks, not standard market terms. What you get depends on your volume and relationship.
TermAsk forWhy
PaymentUPI or bank transfer with a bill, rather than cash with no billGives you a record for returns, tax and your own accounts
Credit periodSeven to fifteen days once you have bought for a few weeksEases cash flow in the early months; confirm the cost in the price
Returns windowThree to seven days for dead-on-arrival parts, and a warranty period on screens and batteriesGets the replacement without arguing
Price protectionA written rate for a fixed number of days on parts you buy weeklyParts prices move with each launch and each import shipment
Minimum orderNone, or a small oneKeeps your stock lean for models you see rarely
GST invoiceEvery purchase, with the supplier's GST numberInput tax credit applies only against proper invoices when you are registered

GST on repair parts and repair services is commonly quoted at 18 percent, but I have not verified the current rate against the official schedule and the classification of parts and labour has been debated. Ask your CA how to invoice parts and labour together or separately and how input credit flows. This is not tax advice. Our GST billing software guide covers the invoice side.

Stock rules: what to hold and what to order

  • Hold the displays, batteries and docks for the ten phone models you see most, in the grades you sell. That usually means five or six brands' popular budget and mid-range models.
  • Order on demand for older, rarer or flagship models. A phone that came in on Monday does not need a part sitting in stock since March.
  • Count weekly and write down what was used. Parts for a model released two years ago lose value quickly.
  • Sell slow stock to another shop at a small discount before it becomes scrap, and send dead boards to your authorised e-waste recycler.
  • Use a minimum stock sheet with reorder levels per model, ordering on Monday and Thursday so that the runner or distributor delivers in time for the weekend rush.

Keep the working capital for parts proportional to your daily jobs. A shop that does 10 jobs a day does not need the stock of one that does 40. For how to plan the numbers, see the wholesale distribution playbook from the supplier's side, and for the bench itself see what to buy.

Selling to other shops: the reverse side

Once you have a reliable source and a skilled technician, other shops become customers. Smaller counters that only change screens and batteries send board-level jobs, and some buy parts from shops with a better supplier.

  • Job work for neighbouring shops at an agreed price per fault type, with their name on the job card and your warranty on the repair.
  • Parts resale to a few nearby shops at a small margin, with the same grade labels and returns policy you get yourself.
  • Written terms: payment within a week, returns policy and who owns the customer relationship; it is easy for a good deal to turn into an argument.

Shop-to-shop work needs a clean tracking system for who sent which phone and what is owed, which the software page covers.

In the mobile repair shop library

More on starting a mobile repair shop

Questions people ask

Where do mobile repair shops buy spare parts in India?

Most buy from wholesale electronics markets such as Nehru Place and Gaffar Market in Delhi, Lamington Road in Mumbai, SP Road in Bengaluru, Ritchie Street in Chennai and Jagdish Market in Hyderabad, or from distributors who deliver from those hubs. Some also use refurbishers and B2B marketplaces. Test small lots before committing.

What is the difference between original, OEM and compatible mobile screens?

Original or pulled-original panels are genuine and cost the most. OEM or service-pack style panels are made to spec but lack the brand's own markings and cost less. Hard OLED, incell or compatible panels are cheapest and usually shift colour or draw more power. Tell customers which grade you fit and give a shorter warranty on cheaper ones.

How do I know if a parts supplier is reliable?

Order small test lots from two suppliers at once, bench-test every part, label it by supplier and log failures. Track the dead-on-arrival rate and comebacks after fitting. A reliable supplier gives a GST bill, accepts bench-test failures within the agreed window and keeps grades consistent from lot to lot.

Can I get credit from spare parts suppliers?

Often, after a few weeks of regular buying. Ask for seven to fifteen days of credit and a return window for dead-on-arrival parts. Expect the seller to price the credit into the rate. Pay by UPI or bank transfer against a GST bill so you have a record and can claim input credit once registered.

Should I import parts directly from China?

Not as a first shop. Direct import brings customs, shipping, currency, minimum orders and the risk of receiving an entire lot of poor grade, and you cannot easily return it. Build volume with a local distributor first, and revisit import only if you are buying in large lots for several shops and have taken advice on customs and duties.

Menu

Read

Ask an expert Ask an expertFree, real peopleHub
Ask an expert